Screw air compressor failure analysis

The analysis of the cause of the failure and the solution are as follows: (1) Whether the condensed water discharged from the trap has a large oil content, if so, check the leakage point in the unit and eliminate it, check whether the oil level of the compressor is too high, if so, reduce the oil level; (2 ) Whether the opening pressure of the minimum pressure valve is normal, if so, troubleshoot, and it is necessary to replace the valve; check whether the oil return pipe is blocked, if so, clean or replace the oil return pipe: (3) Replace the oil separator core. [pdf]

Dth drilling rig method

DTH is short for “down-the-hole”. Since the DTH method was originally developed to drill large-diameter holes downwards in surface-drilling applications, its name originated from the fact that the percussion mechanism followed the bit down into the hole. Applications were later found for the DTH method. . A down-the-hole drill, usually called DTH by most professionals, is basically a screwed on the bottom of a . The fast hammer action breaks hard rock into small cuttings and dust that are evacuated by a. . A is first thought to have been used for rock drilling in 1844. Many quarries used hand held tools that required the driller to suspend himself from a rope over the. . In DTH drilling, the percussion mechanism – commonly called the hammer – is located directly above the drill bit. The drill pipes transmit the necessary feed force and rotation to the hammer and the bit, along with the fluid (air, water or drilling mud) used to. . DTH products can be used in the following applications:• Mining- drill and blast holes in open pit mining, where the drill operator will drill several holes, then. In down-the-hole drilling a drill rod is fitted with a hammer at its lower end. The hammer, which is mounted on the drill bit, is activated through the addition of compressed air and driven into the ground – simultaneously rotating and impacting. [pdf]

Screw air compressor heat sink cleaning method

This can be done by wiping it down with a dry cloth and then spraying the cloth with compressed air to remove any debris on the surface. If there are stubborn stains or dirt, you may need to use some type of cleaners like soap and water or wax and grease remover. [pdf]