The waste hot recovery equipment introduces high-temperature circulating oil and high-temperature compressed air into the heat water unit. The heat generated during the operation of the air compressor is fully absorbed by the water heater. And the compressor can be cooled down at the same time.
[pdf] To connect two compressors in parallel, follow these steps: Make sure both compressors have the same voltage and phase. Install a check valve on each compressor’s discharge line to prevent backflow. Install a tee fitting on each compressor’s discharge line. Connect the two tee fittings with a pipe..
To connect two compressors in parallel, follow these steps: Make sure both compressors have the same voltage and phase. Install a check valve on each compressor’s discharge line to prevent backflow. Install a tee fitting on each compressor’s discharge line. Connect the two tee fittings with a pipe..
The Short Answer: The basic process involves setting up a single pressure switch system linking both compressors, using a check valve to prevent air backflow, and using suitable hoses or pipes.
[pdf] Due to the growing need for the compressed air of higher quality, the water-lubricated twin-screw compressor with water as the only liquid in the compressor has drawn much attention to produce clean air a.
[pdf] 
