The results of the experimental study for the compressive strength and the abrasivity of the rock samples are given in Table 1. It is seen that, with increase in compressive strength abrasivity of rock samples also increases. This may be attributed to increase in the resistance of rocks to wear with increase in the. .
Regression analysis is the statistical methodology for predicting values of one or more dependent variables from a collection of (independent) variables.. .
The coefficient of correlation between the measured and predicted values is a good indicator to check the prediction performance of the model. In this study, values.
[pdf] 
Drilling derricks and Rig Masts consist of a steel framework with a square or rectangular cross-section. Their purpose is to support the hoisting equipment and rack the tubulars while tripping pipe. The number of joints in a stand (single-double-triple) that the rig can pull is dependent on the height of the derrick. .
The Drawworks is one of the most important components of the drilling rig (types of drilling rigs). The unit supplies the hoisting power, the. .
The Crown Blockas a drilling rig component is a fixed set of pulleys (called sheaves) located at the top of the derrick or mast, where the drilling line is threaded. The companion blocks to these pulleys are the traveling blocks. By using two sets of blocks in this fashion,. .
The Traveling Blockis a set of sheaves (pulleys) that move up and down in the derrick. The drilling line is threaded (reeved) over the. .
Attached to the bottom of the traveling blocks, the hook is required to hang the swivel and rig kelly(for drilling) and the elevator bales (for tripping pipe and casing).
[pdf] Rotary bits drill the formation using primarily two principles: 1. Rock removal by exceeding its shear strength and 2. Removal by exceeding the compressive strength. The broken rock is removed by rotary s.
[pdf] 
