Exploration drilling projects in arctic and northern regions often take place in remote, cold, isolated and demanding locations such as lakes, muskeg areas and oceans. One of the major challenges for these projects is the lack of infrastructure making it unfeasible to employ barges or drilling vessels to support project. .
Ice pads can be grounded or floating depending on the water depth and the ice thickness required to support the intended loads. The design load should account. .
Ice pads can be constructed by free-flooding, with spray ice or with chipped ice. Typically, free-flooding is the most cost effective construction method however. .
The bearing capacity of the ice pad depends on the quality of the constructed ice. Proper construction procedures must be employed to ensure the highest ice.
[pdf] Let me explain how a rotary screw element is built up. See this example picture of an oil-free screw element. Compressor element (oil-free type). Photo: Atlas Copco Of course, we see the two rotors (male rot.
[pdf] Before starting casing, the drilling supervisor should hold a pre-job safety meeting and confirm the following with the crew: 1. Remove unnecessary tools. 2. Good Housekeeping before the job 3. Rig up Casing handling equipment: Using appropriate hand. .
A circulation sub, fitting the casing thread, equipped with a WECO connection, shall be readily available on the rig floor at all times during casing running.
[pdf] 
