Either an electrical problem, or the compressor has tripped on a safety device. Check supply power. Check for errors on display. Check emergency stop is out. Check and reset the overload relay. If it’s a new installation, check the phase sequence. Ambient temperature too high or not enough ventilation.
[pdf] Each screw machine must be equipped with a gas storage tank and, if needed, auxiliary equipment such as a cold dryer and a filter. The installation requirements are as follows: A) The installation sequence of supporting equipment is: “air compressor → gas tank → gas-water separator → cold dryer.”
[pdf] Rotor clearance issues or debris can lead to metallic contact sounds Loose or worn belts squeal or howl, especially under load Airflow pulsations, valve leaks, or turbulence create hissing or whistling Bolts, nuts, and mounting pads loosen over time, amplifying noise
[pdf] 
