How do you disassemble a hammer?

When disassembling the hammer, place the clamps of the break-out bench or drill rig in the Clamping Zones. The Clamping Zones are clear of the threads and of the piston bore. Placement of clamps on any other section of the Wear Sleeve can cause severe damage, alter drilling performance, and will void any warranty.

How do you drill a hole with a hammer?

A WRAP-AROUND WRENCH TO GRIP THE WEAR SLEEVE.Once the ham er is connected, check the travel of the bit. In the drilling position, the bit should shoulder on the chuck and when the hammer is pul should drop out 1.2” (30mm).2.11 DrillingWith the hammer/bit up off the bottom of the hole, supply air to the hammer. The air will blow thr

Can you use a hammer to clean a drill?

Do not use it to clean anything but the hammer, and make sure it doesn’t blow anything into the hammer. All safety precautions must be followed. Improper or negligent use of hammers and other drilling products can result in bodily injury or death to persons, and/or severe damage to the hammer and parts.

How do you clean a hammer rig?

ons and coat all the internal parts with oil. If the hammer is in a wet hole, bring the hamme above the water level before blowing it out. Short termIf the hammer will be off the rig for no more than 3 weeks, blow air and oil only through the hammer for

How should a drill hammer be adjusted?

Proper adjustment ensures prevention of part damage and correct hammer operation. On occasion, excess oil will drain down the drill rods into the hammer when it is not in use, and may demand a cleaning of the parts. Also, when using the hammer in cold and wet conditions, place it as far into the hole as possible to take advantage of ground heat.

How often should a drill hammer be inspected?

When used for standard dry drilling (little or no water), an inspection every 175 hours to 200 hours will be enough. When using the hammer in wet conditions, in holes where mud is found, in water wells, when using water or foam injection, or when drilling in very hard rock, an inspection should take place every 100 hours.