A TUTORIAL ON DRAWING HIGHLY DETAILED ROCK FACES
Down-the-hole drill slag removal video tutorial
A down-the-hole drill, usually called DTH by most professionals, is basically a screwed on the bottom of a . The fast hammer action breaks hard rock into small cuttings and dust that are evacuated by a fluid (air, water or ). The DTH hammer is one of the fastest ways to drill hard rock. The system is thought to have been invented independently by Stenuic. [pdf]FAQS about Down-the-hole drill slag removal video tutorial
What is a down-the-hole drilling method?
The video shows the down-the-hole drilling method for very hard soil or rock. A rotary drilling rig, type LB 20, working with down-the-hole hammer inside a casing. A flushing current conveys the loosened drill cuttings upwards and exits at the upper end of the casing.
How does a down-the-hole drill work?
In down-the-hole drilling a drill rod is fitted with a hammer at its lower end. The hammer, which is mounted on the drill bit, is activated through the addition of compressed air and driven into the ground – simultaneously rotating and impacting. A flushing current collects the loosened drill cuttings and conveys them upwards.
What is down-the-hole (DTH) drilling?
Down-the-hole (DTH) drilling has made it easier for contractors to drill wells faster and more efficiently, and to transition from dirt boring to rock boring just by adding a compressor and hammer to the drill bit.
How do you drill a rock with a DTH hammer?
This method is mainly applied for hard to very hard rock and/or for penetrating large boulders. 1. Setting the DTH hammer with drill rod and casing on the drilling point. 2. Rotary and percussive drilling of the drill string under compressed air supply. 3. After reaching the final depth, unlocking of the drill rod with DTH hammer and pilot bit.
How does DTH drilling work?
With DTH drilling, contractors can change the drill that they were using for the current directional bore to a rock drill when they encounter rock by connecting the drill with a compressor and a steerable hammer. Well drilling also needed changes to be made to rotary drilling when the well needed to take a turn.
How does DTH hammer drilling work?
A flushing current conveys the loosened drill cuttings upwards and exits at the upper end of the casing. If you have any further questions, please contact our local sales or service team. DTH hammer drilling is a percussive drilling process powered by compressed air.
Drilling rig power head drawing
Drilling derricks and Rig Masts consist of a steel framework with a square or rectangular cross-section. Their purpose is to support the hoisting equipment and rack the tubulars while tripping pipe. The number of joints in a stand (single-double-triple) that the rig can pull is dependent on the height of the derrick. . The Drawworks is one of the most important components of the drilling rig (types of drilling rigs). The unit supplies the hoisting power, the. . The Crown Blockas a drilling rig component is a fixed set of pulleys (called sheaves) located at the top of the derrick or mast, where the drilling line is threaded. The companion blocks to these pulleys are the traveling blocks. By using two sets of blocks in this fashion,. . The Traveling Blockis a set of sheaves (pulleys) that move up and down in the derrick. The drilling line is threaded (reeved) over the. . Attached to the bottom of the traveling blocks, the hook is required to hang the swivel and rig kelly(for drilling) and the elevator bales (for tripping pipe and casing). [pdf]