In a drilling rig, the drill line is a multi-thread, twisted wire rope that is threaded or reeved through in typically 6 to 12 parts between the traveling block and crown block to facilitate the lowering and lifting of the drill string into and out of the wellbore.
[pdf] A flow line, used on a drilling rig, is a large diameter pipe (typically a section of casing) that is connected to the bell nipple (under the drill floor) and extends to the possum belly (on the mud tanks) and acts as a return line (for the drilling fluid as it comes out of the hole), to the mud. .
The is used to slow the flow of returning before it hits the . This enables the shale shaker to clean the. .
A stinger line is similar to a flow line, but unlike a flow line is not used to maintain circulation. The stinger line is attached to the .
Another common add on is the sample box. This is a heavy duty rubber hose that is inserted at the end of the flow line and at the other end emplaced into the sample box itself. The.
[pdf] Before starting casing, the drilling supervisor should hold a pre-job safety meeting and confirm the following with the crew: 1. Remove unnecessary tools. 2. Good Housekeeping before the job 3. Rig up Casing handling equipment: Using appropriate hand. .
A circulation sub, fitting the casing thread, equipped with a WECO connection, shall be readily available on the rig floor at all times during casing running.
[pdf] 
