This is the tank from which drilling fluid is pumped downhole and to which drilling fluid returns from the hole is received. The route taken by the drilling fluid when circulating is called the active (circulating) system. At the start of circulation, the Mud Pumps are lined up on the Active Tank, and drilling fluid is pumped to. .
These are used for storing fluids according to requirements. Reserve mud is usually prepared or stored in these tanks or different fluids in preparation for. .
The Sand Traps are usually positioned below the shale shakers and act as settling pits for the drilling fluid after passing through the shale shakers. The. .
These tanks are more minor than active and reserve tanks. They are used for preparing “slugs” (high-density mud that is pumped into the drill string before tripping out of the hole) and pills to address particular situations (e.g. an LCM pill to control formation losses, a unique mix to improve drilling mud properties, etc.). .
The Trip Tank is a tall, narrow tank located near the flow line and used for accurately monitoring drill pipe displacement volumes while tripping pipe in or out of the hole. Active drilling mud from the Trip Tank is circulated across the hole, and valves in the flow line near the Bell Nipple are realigned to send the fluid returns back to the Trip .
[pdf] 
Land rigs are generally either wheel-mounted portable types or a component system that must be moved by trucks and cranes. The drilling floor generally sits on top of a steel substructure that could be 30 feet high or more. A drilling mast (derrick) is attached to and raised above the floor. In general, the deeper. .
One of the Oil Rig Hazards types is the hostile environment. The effects of greater water depths, storms, wave action, and uncertain exploratory data all greatly increase the financial. .
Drill ships are ships specially built and modified to drill in deep water or in operations that are not suitable for semi-submersible rigs. Drill ships are self-propelled and can. .
and drilling rigs are used not only to identify geologic reservoirs, but also used to create holes that allow the extraction of oil or natural gas from those reservoirs. Primarily in onshore oil and gas fields once a well has been drilled, the drilling rig will be moved off of the well and a service rig (a smaller rig) that is purpose-built for completions will be moved on to the well to get th.
[pdf] A Mud Engineers are key player in the oil and gas industry. Their job is to manage drilling fluids, also known as “mud,” which are essential for drilling operations. These fluids keep the drill bit cool, carry rock cuttings to the surface, and stabilize the wellbore.
[pdf] 