This can be done by wiping it down with a dry cloth and then spraying the cloth with compressed air to remove any debris on the surface. If there are stubborn stains or dirt, you may need to use some type of cleaners like soap and water or wax and grease remover.
[pdf] use caustic soda solution (Concentration 8-10%) Heat to 60℃ and soak the handpiece for 24 hours. cooler Use a high-pressure water gun (pressure>15MPa) to back-flush the copper tube. replacement All-oil sealing ring Avoid corrosion by residual cleaning agents.
[pdf] The waste hot recovery equipment introduces high-temperature circulating oil and high-temperature compressed air into the heat water unit. The heat generated during the operation of the air compressor is fully absorbed by the water heater. And the compressor can be cooled down at the same time.
[pdf] 
