The waste hot recovery equipment introduces high-temperature circulating oil and high-temperature compressed air into the heat water unit. The heat generated during the operation of the air compressor is fully absorbed by the water heater. And the compressor can be cooled down at the same time.
[pdf] This can be done by wiping it down with a dry cloth and then spraying the cloth with compressed air to remove any debris on the surface. If there are stubborn stains or dirt, you may need to use some type of cleaners like soap and water or wax and grease remover.
[pdf] The analysis of the cause of the failure and the solution are as follows: (1) Whether the condensed water discharged from the trap has a large oil content, if so, check the leakage point in the unit and eliminate it, check whether the oil level of the compressor is too high, if so, reduce the oil level; (2 ) Whether the opening pressure of the minimum pressure valve is normal, if so, troubleshoot, and it is necessary to replace the valve; check whether the oil return pipe is blocked, if so, clean or replace the oil return pipe: (3) Replace the oil separator core.
[pdf] 
