In this video we assemble a DIY micro drill rig (tiny DC motor + drill bit + frame) and a submersible water pump, then test drilling a small “well” and pumping water through tubing. I explain the mechanism, torque limits, and 3 upgrades for better performance.
[pdf] Both high-pressure mud pumps are utilized on rigs to circulate the drilling fluidaround. Each type, however, has its operating limits,. .
The speed of the piston is not constant during the suction and discharge strokes. During each stroke, the speed increases from zero to maximum at approximately the halfway position. .
Mud pumps must be equipped with pressure relief valves. These valves prevent too high a pressure from being built up in the circulating system. The relief valves most.
[pdf] Drill stems must be designed to transfer drilling torque for combined lengths that often exceed several miles down into the , and also must be able to resist pressure differentials between inside and outside (or vice versa), and have sufficient strength to suspend the total weight of deeper components. For deep wells this requires tempered steel tubes that are expensive, and owners spend considerable efforts to reuse them after finishing a well.
[pdf] 
