The rotating head can be defined as a rotating, low-pressure sealing device used in drilling operations to seal around the drill stem above the top of the blowout preventer stack. Rotating drilling heads are used to safely divert air, gas, dust, or drilling mud away from the rig floor.
[pdf] We will start our trip through the loop at the same place we will finish: The oil sump. This reservoir is where oil is stored for use in the system. It is usually located in the lower section of a tank-like cylinder.
[pdf] Either an electrical problem, or the compressor has tripped on a safety device. Check supply power. Check for errors on display. Check emergency stop is out. Check and reset the overload relay. If it’s a new installation, check the phase sequence. Ambient temperature too high or not enough ventilation.
[pdf] 
