Drilling derricks and Rig Masts consist of a steel framework with a square or rectangular cross-section. Their purpose is to support the hoisting equipment and rack the tubulars while tripping pipe. The number of joints in a stand (single-double-triple) that the rig can pull is dependent on the height of the derrick. .
The Drawworks is one of the most important components of the drilling rig (types of drilling rigs). The unit supplies the hoisting power, the. .
The Crown Blockas a drilling rig component is a fixed set of pulleys (called sheaves) located at the top of the derrick or mast, where the drilling line is threaded. The companion blocks to these pulleys are the traveling blocks. By using two sets of blocks in this fashion,. .
The Traveling Blockis a set of sheaves (pulleys) that move up and down in the derrick. The drilling line is threaded (reeved) over the. .
Attached to the bottom of the traveling blocks, the hook is required to hang the swivel and rig kelly(for drilling) and the elevator bales (for tripping pipe and casing).
[pdf] A common drill rig used for "Shot Hole Drilling" is the L.I.S (Low Impact Seismic) mounted on track carrier for operation in cut lines or environmentally sensitive area. Truck mounted drill or 4X4 buggy are utilized in the prairies. These drill rigs use water or air to assist the drilling.
[pdf] On Thursday, November 20, 1980, the drill assembly of a Texaco contracted oil rig, just offshore of the salt dome-caused Jefferson Island (itself in the east southeast section of Lake Peigneur), pierced an inactive third level of the Diamond Crystal Salt Company salt mine.OverviewLake Peigneur is a lake in the of , 1.2 miles (1.9 kilometers) north of and. .
In , the formation of a often pushes terrain upward from the surrounding land, while also creating a subterranean , holding petroleum deposits. On Thursday, November. .
• (archived)• on •.
[pdf] 
