Should be in the mage-ohms (you need an isolation tester / high voltage ohm meter for this). Check the voltage when the compressor is running. If the voltage drop significantly when the compressor starts/runs, you have a bad connection somewhere. Check all relays, fuses and electrical connections.
[pdf] There is dirt stuck in the wind flap or other rotating parts 1. Send the minor repair station in time to remove or replace the necessary parts. 3. If you use the air duct to refuel, do not add too much fuel at a time, but you must work hard.
[pdf] A down-the-hole drill, usually called DTH by most professionals, is basically a screwed on the bottom of a . The fast hammer action breaks hard rock into small cuttings and dust that are evacuated by a fluid (air, water or ). The DTH hammer is one of the fastest ways to drill hard rock. The system is thought to have been invented independently by Stenuic. DTH drilling rig, short for Down-The-Hole drilling rig, is a cornerstone of modern drilling technology. Renowned for its efficiency, precision, and versatility, this equipment has revolutionized industries ranging from mining and construction to geothermal energy exploration.
[pdf] 
