Should be in the mage-ohms (you need an isolation tester / high voltage ohm meter for this). Check the voltage when the compressor is running. If the voltage drop significantly when the compressor starts/runs, you have a bad connection somewhere. Check all relays, fuses and electrical connections.
[pdf] 
We will start our trip through the loop at the same place we will finish: The oil sump. This reservoir is where oil is stored for use in the system. It is usually located in the lower section of a tank-like cylinder, that also houses components used in the air/oil separation. .
Oil from the sump flows through small entry passages around the outside of the filter base and is forced through an opening near the closed side of the filter casing, where it. .
Our next stop, assuming our lubricant has reached its operating temperature will be to the oil cooler. As our lubricant has been subjected to extreme friction and bears the brunt of temperature. .
This is our first stop in our trip through the system. This valve will direct our lubricant towards its next component based on temperature. Just. .
This component, like the radiator in your car, passes the fluid through tubing encased in a block of baffles, designed to optimize heat transfer. Most air-cooled air compressors have a high capacity fan which will force air through the baffles, and out of the cabinet,.
[pdf] Major industrial compressor filter manufacturers include globally recognized brands like 3M, Parker Hannifin, and Donaldson, alongside specialized Chinese producers like Xinxiang Lvda and Shandong Sparta.
[pdf] 
