The air below the deck is typically hot, humid and saline. It’s not a friendly environment, and your compressor’s build quality needs to reflect this. The process starts with the compressor sucking in air from the surroundings. It enters the air end, which houses the screws. Oil is injected, acting as a lubricant. .
The screws push the air into an oil separator receiver. This unit consists of two stages: 1. High-efficiency cyclone separator 2. Oil. .
Having passed through the filter, the air is ready for some cooling. The non-return discharge valve, which only opens at a minimum positive pressure, lets the air through in appropriate measures. To cool down the compressed air to a level that will be acceptable for. .
A marine air compressor needs a proper water separator. By proper, we mean a cyclone separator with level-controlled drainage. The conventional approach is to use a solenoid valve on a timer. It opens up on regular intervals, causing pressure from the compressor.
[pdf] 
Frequent rotation in the directional well forms a keyway, and the drill rod is stuck in the keyway. Preventive measures: Regularly perform short trips to repair the wellbore and control dogleg deviation..
Frequent rotation in the directional well forms a keyway, and the drill rod is stuck in the keyway. Preventive measures: Regularly perform short trips to repair the wellbore and control dogleg deviation..
Before drilling, inspect the condition and lubrication of all drill string components, including the hammer or drifter. Replace any worn out parts, following manufacturer’s recommended discard limits closely. Snake skin is a wear pattern of micro cracks that develop from drilling fatigue in non-abrasive rock..
This chapter contains some common types of failures occurring on DTH drilling tools For most failures we can identify it’s probable cause and typical supporting evidence.
Rod connection and removal are crucial aspects of down-the-hole drill operations, directly impacting overall work efficiency and the service life of rock drilling tools..
It was possible that the rig was drilling in severe drilling conditions, or that the driller was pushing too hard or had a poor drill string design. I asked some questions as to hole sizes, depths, etc.
[pdf] The first step is to ensure that the hydraulic system is shut down and the pressure is relieved. Then, the cylinder should be disconnected from the hydraulic system and the cylinder head should be removed. Once the cylinder head has been removed, the piston rod can be manually retracted by hand.
[pdf] 
