Drilling derricks and Rig Masts consist of a steel framework with a square or rectangular cross-section. Their purpose is to support the hoisting equipment and rack the tubulars while tripping pipe. The number of joints in a stand (single-double-triple) that the rig can. .
The Crown Blockas a drilling rig component is a fixed set of pulleys (called sheaves) located at the top of the derrick or mast, where the drilling line is threaded. The companion blocks to these pulleys are the traveling blocks. By using two sets of blocks in this fashion,. .
Attached to the bottom of the traveling blocks, the hook is required to hang the swivel and rig kelly(for drilling) and the elevator bales (for tripping pipe and casing). .
The Drawworks is one of the most important components of the drilling rig (types of drilling rigs). The unit supplies the hoisting power, the. .
The Traveling Blockis a set of sheaves (pulleys) that move up and down in the derrick. The drilling line is threaded (reeved) over the.
[pdf] For water-lubricated twin-screw compressors, the estimation of leakage flow remains one of the most important problems related to screw compressor design, performance prediction and improvement. In this.
[pdf] 
If the customer’s environment is caustic or extremely dirty, a water-cooled solution may be the best fit. There are many different designs of cooling towers and each has its advantages and disadvantages. Customer need to consider the initial cost of the tower plus the energy required and maintenance that goes along. .
Air-cooled compressors require adequate amounts of cooling air for the inlet and enough space for discharge. Without enough space, customers may encounter temperature regulation issues which can cause nuisance shutdowns or equipment failures. Ductwork to. .
Considering escalating water costs and regulations, plants have sought ways to decrease their cooling water requirements. Compressed air systems consume a high volume of water to. .
Water-cooled units can require less power compared to an air-cooled compressor, but customers should also consider the electrical costs of the cooling system, water and water treatment costs when opting for water-cooled. Once factoring in those expenses, air.
[pdf] 