You need to remove the "T" or "L" connector from the top of the nozzles bulkhead assy. Press down on the bulkhead's collet, while pulling on the "T" connector to safely remove. Then remove the top nut off the bulk head. Now take your nozzle and insert it up and through the hole in the cage corner.
[pdf] Each screw machine must be equipped with a gas storage tank and, if needed, auxiliary equipment such as a cold dryer and a filter. The installation requirements are as follows: A) The installation sequence of supporting equipment is: “air compressor → gas tank → gas-water separator → cold dryer.”
[pdf] The longer your feed rail, the more important the addition of the energy chain becomes to the overall effectiveness of your machine. We offer a range of feed rail options from 6′ to 24′ for our Skid Steer and E.
[pdf] 
