Deepwater drilling, or deep well drilling, is the process of creating holes in the using a for under the deep sea. There are approximately 3400 deepwater wells in the with depths greater than 150 meters. Deepwater drilling has not been technologically or economically feasible for m.
[pdf] In the early 1960s, Brewster-Bartle, an onshore drilling company, filed . In 1964, Don McMahon acquired Brewster-Bartle from its bank creditors and formed Diamond M Drilling Company, named after Diamond. .
In 1989, Diamond's predecessor bought 6 drilling rigs from the predecessor of Kaneb Management. Some of Kaneb's employees continued to work for Diamond after the transaction and then sued Diamond for personal inj.
[pdf] 
Drilling derricks and Rig Masts consist of a steel framework with a square or rectangular cross-section. Their purpose is to support the hoisting equipment and rack the tubulars while tripping pipe. The number of joints in a stand (single-double-triple) that the rig can pull is dependent on the height of the derrick. .
The Drawworks is one of the most important components of the drilling rig (types of drilling rigs). The unit supplies the hoisting power, the. .
The Crown Blockas a drilling rig component is a fixed set of pulleys (called sheaves) located at the top of the derrick or mast, where the drilling line is threaded. The companion blocks to these pulleys are the traveling blocks. By using two sets of blocks in this fashion,. .
The Traveling Blockis a set of sheaves (pulleys) that move up and down in the derrick. The drilling line is threaded (reeved) over the. .
Attached to the bottom of the traveling blocks, the hook is required to hang the swivel and rig kelly(for drilling) and the elevator bales (for tripping pipe and casing).
[pdf] 
