Before making any repairs, be sure the unit is unplugged and tank has no air. To remove the line and load cords from the pressure switch, the pressure switch cover will need to be removed. Use your Phillips head screwdriver to loosen the screw located either on the top or on the side of the cover.
[pdf] Each screw machine must be equipped with a gas storage tank and, if needed, auxiliary equipment such as a cold dryer and a filter. The installation requirements are as follows: A) The installation sequence of supporting equipment is: “air compressor → gas tank → gas-water separator → cold dryer.”
[pdf] When matching motor characteristics to compressor requirements, one should consider factors such as voltage, phase, and duty cycle. The motor’s rated horsepower should ideally be closely matched to the compressor’s demands to ensure optimal performance.
[pdf] 
