While the mechanics of drilling a well are very similar for floating, bottom-founded and onshore operations, the po-tential safety and environmental consequences of an inci-dent ofshore,. .
Another proactive step typically taken to mitigate the in-creased risks of ofshore operations is a shallow hazard assessment, which will examine the risks that might be. .
Simultaneous operations plans (SIMOPs) are developed to consider additional risks that occur when two work activities are being done at the same time within close proximity to one another. Communication of SIMOPs risks and hazards during floating drilling. .
Several proactive steps are typically taken to mitigate the in-creased risks of ofshore operations. One of these proactive measures is an environmental impact assessment (EIA), a. .
Hazard assessments are also conducted for ofshore safe-ty concerns. Safety cases identify the hazards and risks of various operations, and then document how the risk is controlled and.
[pdf] The IADC Drilling Manual has recently been updated and is now available in its 13th edition in the IADC Bookstore. This book is the definitive manual for drilling operations, training, maintenance and troubleshooting.
[pdf] 
Drilling derricks and Rig Masts consist of a steel framework with a square or rectangular cross-section. Their purpose is to support the hoisting equipment and rack the tubulars while tripping pipe. The number of joints in a stand (single-double-triple) that the rig can pull is dependent on the height of the derrick. .
The Drawworks is one of the most important components of the drilling rig (types of drilling rigs). The unit supplies the hoisting power, the. .
The Crown Blockas a drilling rig component is a fixed set of pulleys (called sheaves) located at the top of the derrick or mast, where the drilling line is threaded. The companion blocks to these pulleys are the traveling blocks. By using two sets of blocks in this fashion,. .
The Traveling Blockis a set of sheaves (pulleys) that move up and down in the derrick. The drilling line is threaded (reeved) over the. .
Attached to the bottom of the traveling blocks, the hook is required to hang the swivel and rig kelly(for drilling) and the elevator bales (for tripping pipe and casing). .
• (#22) is a section of large diameter pipe fitted to the top of the that the attaches to via a side outlet, to allow the to flow back to the .• (BOPs) (#23 and #24) are devices installed at the wellhead to prevent fluids and gases from unintentionally escaping from the . #23 is the annular (often referred to as Hydril named after a manufacturer), and #24 is the pipe rams and blind rams.
[pdf] 
