We will start our trip through the loop at the same place we will finish: The oil sump. This reservoir is where oil is stored for use in the system. It is usually located in the lower section of a tank-like cylinder.
[pdf] Either an electrical problem, or the compressor has tripped on a safety device. Check supply power. Check for errors on display. Check emergency stop is out. Check and reset the overload relay. If it’s a new installation, check the phase sequence. Ambient temperature too high or not enough ventilation.
[pdf] Even with an air dryer, some moisture will still accumulate in the compressor system. That's why it's crucial to regularly drain the condensate. Most screw air compressors come with automatic drain valves, which are set to open at specific intervals to remove the accumulated water.
[pdf] 
