A rotary drilling rig works by rotating a drill string, which applies downward pressure to a drill bit that grinds the earth. Drilling fluid or air is pumped down the drill string to cool the bit, carry cuttings to the surface, and stabilize the borehole.
[pdf] 
Drilling derricks and Rig Masts consist of a steel framework with a square or rectangular cross-section. Their purpose is to support the hoisting equipment and rack the tubulars while tripping pipe. The number of joints in a stand (single-double-triple) that the rig can pull is dependent on the height of the derrick. .
The Drawworks is one of the most important components of the drilling rig (types of drilling rigs). The unit supplies the hoisting power, the. .
The Crown Blockas a drilling rig component is a fixed set of pulleys (called sheaves) located at the top of the derrick or mast, where the drilling line is threaded. The companion blocks to these pulleys are the traveling blocks. By using two sets of blocks in this fashion,. .
The Traveling Blockis a set of sheaves (pulleys) that move up and down in the derrick. The drilling line is threaded (reeved) over the. .
Attached to the bottom of the traveling blocks, the hook is required to hang the swivel and rig kelly(for drilling) and the elevator bales (for tripping pipe and casing).
[pdf] A rotary table is a mechanical device on a drilling rig that provides clockwise (as viewed from above) rotational force to the drill string to facilitate the process of drilling a borehole. Rotary speed is the number of times the rotary table makes one full revolution in one minute (rpm). ComponentsThe rotary table is also called a turntable. Most rotary tables are chain driven. These chains resemble very large .
Most recently manufactured rigs no longer feature rotary drives. These newer rigs have opted for technology. In top drive, the drill string is turned by mechanisms located in the top drive that is attached t.
[pdf] 
