Drill bits wear and tear like most any other piece of equipment. Once a bit becomes too worn to drill at an adequate rate or make a full-gauge hole, or if the bearings are thought to be near failure, a trip is undertaken to replace the bit. A trip is not considered a bit trip when the purpose of replacing the bit is to change sizes. This is only done when the crew "sets surface, intermediate or longstring. OverviewTripping pipe (or "Making a round trip" or simply "Making a trip") is the physical act of pulling the out of the and then running it back in. This is done by physically breaking out or disconnecting (when pulli. .
A fishing trip is when a crew is forced to trip pipe to retrieve loose items in the . This can result from something being dropped in the hole, i.e. a tool, that would cause damage to the bit if the crew attempted t. The process of pulling the drillstring out of the wellbore for the purpose of changing a worn or underperforming drill bit.
[pdf] The bodies of five workers, including one Texan, were recovered Tuesday after an explosion ripped through a drilling rig in Oklahoma, triggering what appears to be the nation's deadliest oil and gas accident since the 2010 Deepwater Horizon disaster in the Gulf of Mexico.
[pdf] On 24 May 2011, Cactus Rig 117, operating near Calumet, Okla., suffered a direct hit by an F5 tornado that resulted in an estimated $14 million in damage. An F5 tornado damaged Cactus Rig 117 after hitting the site on 24 May 2011. Although the rig was destroyed, all of the rig’s crew survived.
[pdf] 
