The waste hot recovery equipment introduces high-temperature circulating oil and high-temperature compressed air into the heat water unit. The heat generated during the operation of the air compressor is fully absorbed by the water heater. And the compressor can be cooled down at the same time.
[pdf] This can be done by wiping it down with a dry cloth and then spraying the cloth with compressed air to remove any debris on the surface. If there are stubborn stains or dirt, you may need to use some type of cleaners like soap and water or wax and grease remover.
[pdf] When pressing “Enter” the following interface will pop up and the password will be required (9999). NOTE: Customer Password can be modified in the CUSTOMER PARAMETER menu. Page 23 KRSD series ENTER PASSWORD ****. Page 24 UNLOAD P. *.**Mpa Unload pressure setting.
[pdf] 
