DTH is short for “down-the-hole”. Since the DTH method was originally developed to drill large-diameter holes downwards in surface-drilling applications, its name originated from the fact that the percussion mechanism followed the bit down into the hole. Applications were later found for the DTH method. .
A down-the-hole drill, usually called DTH by most professionals, is basically a screwed on the bottom of a . The fast hammer action breaks hard rock into small cuttings and dust that are evacuated by a. .
A is first thought to have been used for rock drilling in 1844. Many quarries used hand held tools that required the driller to suspend himself from a rope over the. .
In DTH drilling, the percussion mechanism – commonly called the hammer – is located directly above the drill bit. The drill pipes transmit the necessary feed force and rotation to the hammer and the bit, along with the fluid (air, water or drilling mud) used to. .
DTH products can be used in the following applications:• Mining- drill and blast holes in open pit mining, where the drill operator will drill several holes, then. In down-the-hole drilling a drill rod is fitted with a hammer at its lower end. The hammer, which is mounted on the drill bit, is activated through the addition of compressed air and driven into the ground – simultaneously rotating and impacting.
[pdf] 
Mobile offshore drilling units (MODU) Semi-submersible rigs make stable platforms for drilling for offshore oil and gas. They can be towed into position by a tugboat and anchored, or moved by and kept in position by their own azimuth thrusters with dynamic positioning. The International Maritime Organization. .
A semi-submersible platform is a specialised used in offshore roles including as rigs, safety vessels, oil production platforms, and heavy lift cranes. They have good .
The semi-submersible design was first developed for activities in the early 1960s. Bruce Collipp of is regarded as the inventor.However, .
• – Consultants designers• – Consultants designers• – Info on Boskalis transport ships• – Photos of Mighty Servant 2 hauling USS Samuel B. Roberts (FFG 58) .
Offshore drilling in water depth greater than around 520 metres (1,710 ft) requires that operations be carried out from a floating vessel, since. .
• • • – facility used to repair and maintain ships; some are floating and can be submerged to load vessels.• – semi-submerging vessel for transportation of.
[pdf] To connect two compressors in parallel, follow these steps: Make sure both compressors have the same voltage and phase. Install a check valve on each compressor’s discharge line to prevent backflow. Install a tee fitting on each compressor’s discharge line. Connect the two tee fittings with a pipe..
To connect two compressors in parallel, follow these steps: Make sure both compressors have the same voltage and phase. Install a check valve on each compressor’s discharge line to prevent backflow. Install a tee fitting on each compressor’s discharge line. Connect the two tee fittings with a pipe..
The Short Answer: The basic process involves setting up a single pressure switch system linking both compressors, using a check valve to prevent air backflow, and using suitable hoses or pipes.
[pdf] 