Both high-pressure mud pumps are utilized on rigs to circulate the drilling fluidaround. Each type, however, has its operating limits,. .
The speed of the piston is not constant during the suction and discharge strokes. During each stroke, the speed increases from zero to maximum at approximately the halfway position. .
Mud pumps must be equipped with pressure relief valves. These valves prevent too high a pressure from being built up in the circulating system. The relief valves most.
[pdf] The drawworks reels in and reels out the drilling line. The drilling line is connected to the traveling block and hook which connect to the drill string. The drill string runs over the crown block and setup like a block and tackle pulley system.
[pdf] Before any workover, the well must first be . Since workovers are long planned in advance, there would be much time to plan the and so the reverse circulation would be common. The intense nature of this operation often requires no less than the capabilities of a . The workover begins by killing the well then removing the wellhead and possibly the flow line, then installing a B.O.P. commonly known as a , then lifting the fr.
[pdf] 
