Check the isolation of the motor windings. Should be in the mage-ohms (you need an isolation tester / high voltage ohm meter for this). Check the voltage when the compressor is running. If the voltage drop significantly when the compressor starts/runs, you have a bad connection somewhere.
[pdf] There is dirt stuck in the wind flap or other rotating parts 1. Send the minor repair station in time to remove or replace the necessary parts. 3. If you use the air duct to refuel, do not add too much fuel at a time, but you must work hard.
[pdf] Gaterotor Gaterotor Support The standard Vilter Single Screw Compressor (as shown in this end view drawing) consists of two rotating gaterotor assemblies and a main screw assembly. All bearings are pr.
[pdf] 
